Skip to content
Commercial stucco & EIFS contractor serving Dunwoody, GA Offices • Retail • Condos • Multifamily • Restaurants Call (470) 533-5476
Advanced Stucco Repair DunwoodyCommercial Stucco & EIFS (470) 533-5476
  1. Home
  2. Services
  3. Stucco Installation
Stucco installation • Dunwoody, GA

Commercial Stucco Installation in Dunwoody

We install three-coat portland cement stucco on commercial and multifamily buildings in Dunwoody: weather barrier, lath, control joints and weep screed done right, then a finish coat in the color and texture the project calls for.

  • Three-coat cement stucco
  • Weather barrier & lath
  • Control joints & screed
  • New work & re-clads
1999Georgia stucco work
Three-coatScratch, brown & finish
WrittenItemized quotes

Request a commercial quote

Dunwoody commercial stucco & EIFS. Property managers, boards, owners & builders.

Thank you. Your request is in, and an Advanced Stucco Repair commercial estimator will contact you shortly. If it is urgent, call (470) 533-5476.

We never share your information. Prefer to talk? Call (470) 533-5476.

Built to drain

Hard coat stucco for Dunwoody’s smaller projects

Not every Dunwoody stucco job is a tower. Much of the new stucco work in the city is on smaller commercial buildings: a medical or professional office along Chamblee-Dunwoody Road, a retail outparcel, an addition to a neighborhood shopping center, or a clubhouse and amenity building at an apartment community. These projects need the same care as a large one, and often have less room for mistakes in the schedule.

Three-coat stucco is durable and handles impact well, but it only works as part of a system. We start with a weather-resistive barrier lapped correctly over the sheathing and integrated with window and door flashing. Lath is fastened into the framing at the right spacing, and control joints are laid out to break the wall into panels that can move without cracking. A weep screed at the base lets water that gets behind the stucco drain out.

The scratch and brown coats are applied and given proper cure time before the finish. That cure time matters most in Georgia’s summer heat, when stucco that dries too fast cracks. Our finish matches the design intent, or the existing building on an addition, using custom-blended color and texture.

Exterior wall being prepared for weather barrier and stucco
1999installing Georgia stucco
What goes into the wall

Every layer of a commercial stucco wall

A finished three-coat wall is a little under an inch thick, but it is built from six separate parts. Skip one and the others cannot make up for it.

Weather-resistive barrier

Barrier lapped top over bottom, so water that gets past the stucco runs down and out instead of into the sheathing.

Lapped like shingles

Metal lath

Self-furred lath fastened into the framing and held off the barrier, so the scratch coat wraps around it and locks in.

Fastened to framing

Weep screed & casing beads

A weep screed at the base lets water drain out; casing beads finish the edges at windows and storefronts with room for sealant.

Clear of grade & paving

Control & expansion joints

Joints break long elevations into panels and isolate floor lines, so building movement shows up at the joint instead of as random cracking.

Laid out before lath

Flashing & kick-outs

Head flashing over openings, parapet and coping details and kick-outs at roof-to-wall lines go in with the barrier, where they can be lapped correctly.

Where most leaks start

Three coats, properly cured

Scratch, brown and finish coats applied in sequence, with base coats kept damp and given time to cure before the next goes on.

No rushing the cure
Which project?

New buildings, additions and re-clads

On new construction we coordinate with the general contractor, framer, window and storefront installers and roofer so barrier and flashing go in in the right order. On an addition, the new wall has to tie into the existing stucco without a visible seam, which means matching texture and planning a joint where old meets new.

A re-clad is the biggest job, and on an occupied building it is planned elevation by elevation: the failed cladding comes off, we inspect and replace damaged sheathing, then install a complete new system before moving on. If the existing stucco is sound and the goal is a new look, a recoat or color change may be all the building needs.

Typical commercial stucco projects
ProjectWhat’s involvedKey detail
New constructionWhole buildingBarrier, lath, three coatsFlashing sequenced with trades
AdditionNew wing or tenant spaceFull system on new framingTexture tied into existing
Re-cladFailed cladding offSheathing checked, new systemPhased around occupants
Partial elevationOne facade or towerNew system to a clean breakJoint at a corner or band
Our process

How a commercial stucco wall is built

Three-coat stucco takes time because each coat has to cure. Much of the schedule is curing, not labor, and that time is what makes the wall last.

Review & prepare

We review drawings and joint layout, check the sheathing, install the weather barrier from the bottom up and integrate it with window, storefront and roof flashing.

  • Joint layout confirmed
  • Barrier lapped correctly
  • Kick-outs installed

Lath & accessories

Weep screed, casing beads, corner aids and control and expansion joints go on with the lath, fastened into the framing and laid out to suit each elevation.

  • Screed set above grade
  • Joints laid out by panel
  • Lath fastened to framing

Three coats & cure

The scratch coat is scored and kept damp, the brown coat is floated flat and allowed to cure, then the finish coat sets the specified texture and color.

  • Base coats moist-cured
  • Cure time between coats
  • Finish to the spec

Bidding new construction or a re-clad?

Bring us in before the windows go in. Flashing, barrier and joint details are easiest to get right early.

Request a commercial quote
New stucco in Dunwoody

Small sites, tight schedules

Dunwoody’s infill projects sit next to open businesses, busy roads and occupied buildings.

On a Dunwoody infill site, the stucco crew may be working a few feet from an open storefront, a parking lot in use or residents walking to their cars. We plan material deliveries, mixing areas and scaffolding with that in mind, keep the site clean and protect adjacent buildings and landscaping. On additions, we tie the new stucco into the existing wall with a detail that keeps the joint from cracking or leaking later.

Medical & professional offices

Hard coat stucco on smaller office buildings, scheduled around neighbors and open parking.

Retail outparcels & additions

New stucco on pad sites and additions, matched to the shopping center’s existing finish.

Amenity buildings

Clubhouses, leasing offices and pool buildings at apartment and condo communities.

  • Dunwoody
  • Chamblee-Dunwoody corridor
  • Mount Vernon Road
  • Dunwoody Village
  • Georgetown
  • Winters Chapel
  • Sandy Springs
  • Peachtree Corners
  • Chamblee
  • Doraville
Questions & answers

Stucco installation questions in Dunwoody

What owners, developers and general contractors ask about new stucco in Dunwoody.

How long does commercial stucco installation take?
Three-coat stucco needs cure time between the scratch, brown and finish coats, so the schedule depends on wall area, weather and sequencing with other trades. We give you a schedule with the quote.
What is the difference between hard coat stucco and EIFS?
Hard coat stucco is cement-based plaster over lath and is very impact resistant. EIFS uses foam board with a reinforced base and synthetic finish, adds insulation and is lighter. Each has its place, and many buildings combine them.
Will new stucco crack?
Hairline cracking is common in cement stucco. Proper control joint layout, lath installation and curing keep cracks small and cosmetic, and we design those details to limit them.
Do we need a permit for stucco work in Dunwoody?
New construction, additions and re-clads generally need permits. Check with the City of Dunwoody building department; on new projects the general contractor usually holds the permit.
Can you match the stucco on our existing Dunwoody building for an addition?
Yes. We blend pigment and aggregate to match the existing color and texture and prepare samples for approval before the finish coat goes on.
How is stucco installation priced?
By wall area, number of openings and details, access, and the finish selected. We provide a written, itemized quote from plans or a site walk.

Request a stucco installation quote in Dunwoody

Share plans or project details. We will review the scope and send a written price and schedule.

Call now Commercial quote